Offering 3D Design, 3D Printing, Engineering, Programming, and Consulting
Welcome to my website! Please check out my Etsy shop while this page is under construction…
I am a Design Engineer by profession with over 20 years of experience. I specialize in:
Please contact me at info@3DCustomDesigns.com for more information or to set up a consultation!
Gen 3 Toyota Tacoma Phone Mount:
Fits phones with case up to 15mm thick, approximately 80mm wide, and any length. Includes charger clamp (bolt & wingnut) and molded in cord routing clips.
To use:
1. Insert charging cord through clamp and attach to phone.
2. Place phone in mount.
3. Tighten charging cord clamp (wingnut).
4. Ensure fit is well aligned by removing and inserting phone a few times.
5. Clip cord into molded-in routing clips.
6. Install into vehicle by snapping in, between trim pieces above audio unit.
7. Plug USB into data jack for Android Auto or Apple CarPlay connection.
Enjoy!
* This is a 3D printed part. There will be layer lines and some minor surface imperfections vs. an injection molded plastic part. Please be advised.
* Printed from ASA, temperature resistant up to 95 degrees C (203degrees F).
* These parts are made to order. I have limited stock on hand but can make more depending on demand.